Petkov V.Mihailov E.Kazakova N.2024-07-162024-07-162024-07-162024-07-162014-02-251314-74711314-7978SCOPUS_ID:84894028087https://rlib.uctm.edu/handle/123456789/1030Optimal conversion of chemical energy of the biomass or other solid fuel into the desired gas depends on proper configuration, sizing, and choice of gasifier operating conditions. Optimum operating conditions are often derived through trials on the unit or by experiments on pilot plants. Simulation, or mathematical modeling, allows the designer or plant engineer to reasonably optimize the operation or design of the plant. The good mathematical model can: find optimum operating conditions or a design for the gasifier, provide information on extreme operating conditions (high temperature, high pressure) where experiments are difficult to perform, provide information over a much wider range of conditions than those obtained experimentally, better interpret experimental results and analyze abnormal behavior of a gasifier, if that occurs. The equilibrium model is independent of the gasifier design which can make them more suitable for a system study of the most important process parameters. The use of an equilibrium model assumes that the residence time of the reactants in the gasifier is high enough to reach chemical equilibrium. For established biomass ultimate analysis, temperature of gasification air and temperature of produced gas, combining the mass balance equations with the equations for the equilibrium constants and equation of energy balance, the equivalence ratio (ER) and composition of produced gas can be obtained. A mathematical model for investigation of the influence of temperature of the produced gas and temperature of gasification air on the process parameters was developed. It can be used for estimation and design of gasification equipment.enArticle