Browsing by Author "Fernandes M."
Now showing 1 - 5 of 5
Results Per Page
Sort Options
Item In vitro bioactivity of 70 wt.% SiO2 - 30 wt.% CaO sol-gel glass, doped with 1, 3 and 5 wt.% NbF5(2012-02-01) Radev L.; Hristova K.; Jordanov V.; Fernandes M.; Salvado I.The 70SiO2-30CaO (wt.%) sol-gel glasses doped with 1, 3 and 5 NbF5 (wt.%) were prepared via polystep sol-gel route. The synthesized glasses were characterized by XRD, FTIR and SEM. Changes in 1.5 SBF solutions were measured by ICP-AES. XRD of the glasses stabilized at 700°C for 6 hours proved the presence of niocalite. FTIR was consistent with XRD data. The in vitro bioactivity study of all glasses prepared were carried out by soaking in 1.5 simulated body fluid (1.5 SBF) at 37°C for 6 and 12 days in static conditions. The FTIR reveals the formation of A-type and B-type carbonate containing hydroxyapatite (CO3HA) layer. Changes in 1.5 SBF solutions, after 6 days of soaking, show that the Ca concentration increased significantly, compared to the initial Ca content in the 1.5 SBF solution before in vitro test. After 12 days of immersion, the Ca concentration decreased, i.e., the formation of HA phase consumed Ca from 1.5 SBF solution. For all soaking times, the concentration of P is much lower than that the used 1.5 SBF. Based on these results we suggest that Ca and P play an active role in the future of the glasses. SEM depicts that the different morphology of hydroxyapatite can be formed as a function of soaking time. © 2011 Versita Warsaw and Springer-Verlag Wien.Item Organic/inorganic bioactive materials part III: In vitro bioactivity of gelatin/silicocarnotite hybrids(2009-10-19) Radev L.; Fernandes M.; Salvado I.; Kovacheva D.In this work we present our experimental results on synthesis, structure evolution and in vitro bioactivity assessment of new gelatin/ silicocarnotite hybrid materials. The hybrids were obtained by diluting gelatin (G) and silicocarnotite (S) ceramic powder with G:S ratios of 75:25 and 25:75 wt.% in hot (40°C) water. The hybrids were characterized using XRD, FTIR, SEM/EDS and XPS. FTIR depicts that the ``red shift`` of amide I and COO- could be attributed to the fact that the gelatin prefers to chelate Ca2+ from S. The growth of calcium phosphates on the surface of the hybrids synthesized and then immersed in 1.5 SBF for 3 days was studied by using of FTIR, XRD and SEM/EDS. According to FTIR results, after an immersion of 3 days, A and B-type CO3HA can be observed on the surface. XRD results indicate the presence of hydroxyapatite with well defined crystallinity. SEM/EDS of the precipitated layers show the presence of CO3HA and amorphous calcium phosphate on the surface of samples with different G/S content when immersed in 1.5 SBF. XPS of the G/S hybrid with 25:75 wt.% proved the presence of Ca-deficient hydroxyapatite after an in vitro test for 3 days. © Versita Warsaw and Springer-Verlag Berlin Heidelberg 2009.Item Preparation of nanostructured porous SiO2-Al2 O3 oxycarbonitride materials obtained by a new chemical precursor method(2009-01-09) Ivanova Y.; Gerganova T.; Fernandes M.; Salvado I.Nanostructured hybrid materials containing Al2O3 were synthesized via a sol-gel method through hydrolysis and co-condensation reactions using trimethylsilyl isocyanate (TMSI) as a new silica source in the presence of tetramethoxysilane (TMOS) and three different quantities (10, 20 and 30 wt.%) of aluminum sec-butoxide (Al(OBusec)3 as a modifying agent. The xerogel nanostructured materials are pyrolyzed in nitrogen atmosphere in the temperature range from 400°C to 1100°C. The transformation of the xerogel hybrid networks into Al-Si oxycarbonitride materials has been investigated by XRD, FTIR, SEM, AFM, and 29Si MAS-NMR. To the best of our knowledge, the work reported here is the first synthesis of porous di-urethanesils modified with aluminum and one of the few examples of alumosilica oxycarbonitride materials. © Versita Warsaw and Springer-Verlag Berlin Heidelberg 2009.Item Silica-based organic-inorganic hybrid materials as potential adsorbents for Hg(II) ions(2013-12-17) Velikova N.; Vueva Y.; Ivanova Y.; Salvado I.; Fernandes M.; Vassileva P.; Georgieva R.; Detcheva A.In the present study four functionalized mesoporous silica materials denoted as BIS-1, BIS-2, BIS-3 and BIS-4 have been synthesized through a simple co-condensation of bis-[3-(trimethoxyosilyl)propyl] amine (BTPA) and tetraethyl orthosilicate (TEOS). The influence of the BTPA amount on the structural and adsorption properties of the resultant materials was investigated. The novel hybrid materials have been characterized by FT-IR, BET, 13C CP MAS NMR and elemental analysis. The adsorption properties of mesoporous organic-inorganic materials containing amine functional groups, regarding Hg(II) ions were studied by the batch method. Experiments were carried out in acidic media. The material BIS-3 exhibits highest adsorption capacity for mercury ions. Kinetics of Hg (II) adsorption on BIS-3 was investigated. Equilibrium experimental data for BIS-3 were fitted to linear Langmuir and Freundlich models. All studied hybrid materials could be successfully used for effective removal of mercury ions from acidic aqueous solutions.Item Silica-carrageenan hybrids used for cell immobilization realizing high-temperature degradation of nitrile substrates(2011-04-01) Kabaivanova L.; Chernev G.; Miranda Salvado I.; Fernandes M.In this work the application of hybrid materials, containing TEOS as source of SiO2 and k-carrageenan in different percentage, synthesized by the sol-gel method at room temperature was studied. They were used as matrices for entrapment of whole Bacillus sp. UG-5B cells, producers of thermostable nitrilase. The effect of the surface area and size and quantity of pores in the synthesized materials on the enzyme activity was evaluated. The process of biodegradation of different concentrations of toxic, potentially carcinogenic and mutagenic substrates by the obtained biocatalysts was investigated. The enzyme reaction takes place by the nitrilase pathway, catalysing nitrile hydrolysis directly to the corresponding carboxylic acid, forming ammonia. At batch experiments the influence of the substrate concentration of different nitriles was tested and 20 mM concentration was found most suitable. A two-step biodegradation process in a laboratory-scale column bioreactor of o-, m- and p-tolunitrile as a mixture was followed. After operation of the system for nine hours for the mixture of substrates at a flow rate of 45 mL h-1 and at 60°C, the overall conversion realized was above 90%, showing a good efficiency of the investigated process. © Versita Sp. z o.o.