Browsing by Author "Yordanova R.M."

Now showing 1 - 3 of 3
  • No Thumbnail Available
    Item
    Application of new surfactants sintering agglomerate
    (2017-01-01) Shapovalov A.N.; Dema R.R.; Nefedyev S.P.; Solomonov C.N.; Yordanova R.M.
    A set of pilot experiments to improve pelletizing through the use of sinter charge humidification of water-soluble organic surface-active agents (surfactants) has been performed in the sintering plant of JSC ``Ural Steel``. It has been found that the surfactants use provides improved granularity of sinter charge and increase of its gas permeability during sintering that ensures better technology and quality. Maximum efficiency from the surfactants use is manifested in the area of optimum moisture content of the sinter charge (7 % - 8 %) at a flow rate of the experimental binder of 1,2 l/h - 1,6 l/h (the surfactant concentration in the aqueous solution is 0,3 ml/l - 0,4 ml/l).
  • No Thumbnail Available
    Item
    Assessment of a new equipment for mechanical testing of materials by a torsion
    (2020-01-01) Bogatov A.A.; Shvarts D.L.; Tolkushkin A.O.; Lezhnev S.N.; Naizabekov A.B.; Yordanova R.M.
    The paper presents the results of an assessment of a new equipment for cylindrical samples testing by a unidirectional and an alternating torsion. A computer simulation of the unidirectional torsion process is carried out to choose the optimal shape of the working part of the test samples. A recommendation on the use of a specific samples configuration is given based on the results of a comparative analysis of the distribution of the stress strain state indicators along the length of the working part. A series of experiments on a torsion of aluminum samples with a different rotation speed and an amplitude of the alternating deformation is carried out. Graphs of the torque during the test of each sample depending on the strain rate and the strain amplitude during the alternating torsion are constructed in accordance with the experimental sensor data.
  • No Thumbnail Available
    Item
    Development and research of the new forging technology of billets in the step-wedge dies
    (2019-01-01) Tolkushkin A.O.; Lezhnev S.N.; Naizabekov A.B.; Panin E.A.; Yordanova R.M.; Zhumagaliyev D.R.
    The article describes the concept of a new forging method of billets with square and rectangular cross-section in dies, which design allows to develop shear and alternating deformation in the deformable metal. A computer simulation of the billet drawing process in the step-wedge dies of two configurations was carried out by the finite element method. A comparative analysis of the stress-strain state showed that the use of the configuration of stepwedge dies with a wedge on the top die and a cavity on the bottom die by the distribution character of the stressstrain parameters is the best option for the implementation of the drawing process of rectangular billets. However, during the deformation in the second configuration dies with a wedge on the top die and a wedge-shaped cavity on the bottom die, respectively, the load force is greater than during deformation in the dies of first configuration with the dies having only wedge protrusions, due to the smaller contact area of the tool with the billet. Experimental studies have shown that after the deformation of billets in step and step-wedge dies of both configurations there is an uniform refinement of the original cast metal structure throughout the whole volume, but the use of step-wedge dies in both cases provides a more intensive refinement of the cast structure for one cycle.